2018 Silverado Front Bumper Valance Removal

Kang Yuda

2016+ Newer Front Bumper Removal 2014 / 2015 / 2016 / 2017 / 2018
2016+ Newer Front Bumper Removal 2014 / 2015 / 2016 / 2017 / 2018 from

If you need to replace or repair the front bumper valance on your 2018 Silverado, it’s important to know the proper steps for removal. Here’s a guide to help you through the process.

Main Content

The front bumper valance on a 2018 Silverado is held in place by a series of clips and screws. To remove it, you’ll need to follow these steps:

Step 1: Remove the Screws

Using a socket wrench, remove the screws that secure the front bumper valance to the vehicle’s frame. There are usually four screws on each side of the valance.

Step 2: Release the Clips

Once the screws have been removed, carefully pull the front bumper valance away from the vehicle’s frame. You may need to release a few clips that hold it in place. Use a flathead screwdriver to gently pry the clips away from the frame.

Step 3: Disconnect the Fog Lights (if applicable)

If your 2018 Silverado is equipped with fog lights, you’ll need to disconnect the wiring harnesses before fully removing the front bumper valance. Simply unplug the harness from each fog light and carefully set the valance aside.


Do I need any special tools to remove the front bumper valance?

No, you only need a socket wrench and a flathead screwdriver.

How long does it take to remove the front bumper valance?

The process should take no more than 30 minutes.

Can I remove the front bumper valance without disconnecting the fog lights?

It’s possible, but it’s not recommended. Disconnecting the fog lights will give you more room to work and prevent any damage to the wiring harnesses.

Do I need to remove the entire front bumper to replace the valance?

No, the valance can be replaced without removing the entire front bumper. However, it’s important to follow the proper removal steps to avoid damaging the bumper or other vehicle components.

Is it easy to reinstall the front bumper valance?

Yes, reinstalling the valance is a straightforward process. Simply reverse the removal steps and make sure all screws and clips are securely in place.


The main benefit of removing the front bumper valance on a 2018 Silverado is easy access to the fog lights or other components behind it. This makes repairs or replacements much simpler and quicker to complete.


Before starting the removal process, make sure you have a clean workspace and all necessary tools on hand. It’s also a good idea to have a friend or assistant help hold the valance while you remove the screws and clips.


Removing the front bumper valance on a 2018 Silverado is a simple process that can be completed with basic tools and a little patience. Follow the steps outlined in this guide to ensure a smooth and successful removal.

Related Article


Kang Yuda

Kang Yuda is the main writer at He is a web developer with primary expertise in article writing, web development, open source, and operating systems.

Leave a Comment